ECU Kits ACT MP48

ECU Kits ACT MP48


Brief Introduction of ACT MP48 ECU

ACT Mp48 ECU is a well-known, high -performance and reliable fuel conversion ECU.

Adopting high technology from Italy, Europe-imported chips to ensure the best quality among peer companies.

Mp48 ECU is disigned for 3/4 cylinder multipoin timed sequential injection engines. While runing on gas, Mp48  detec ts the pertrol injection time and pressure on the rail. It will calculate the equivalent amount of gas to be injected in the intake manifold to replicate the performance of the engine running on petrol.  MP48 is equipped with a diagnosis system on every Gas component, whose status can be monitored by the calibration software during the installation of the system and at any time of the engine lifetime .The feature may prevent malfunctioning problems and makes technical interventions easier.

In addition, the calibration tool makes it simplified to install and set, and much cost is reduced.

MP48 is equipped with a 48-PIN connector, with IP54 high protection against water infiltration, it is easier for cable connection/ disconnection.

 

* Technical Parameters of ACT MP48 ECU:

     Working voltage: 10~16V

     Coil Resistance: over 0.5Ω

     Injector Emulation Resistance: 150Ω

     Ambient Temperature: -40~105 degrees

     Waterproof Level: IP54 water Resistance

     Connection: 48 Pins


ACT 4CYL ECU kits MP36

Previous: 

Next: 

Categories

Email: info@actong.cn

本网站由阿里云提供云计算及安全服务 Powered by CloudDream